c
2025 Sun Hydraulics 1 of 2
MODEL
DKHS
Normally closed, balanced poppet, logic element - pilot-to-open
SERIES 3 / CAPACITY: 240 L/min. / CAVITY: T-23A
(X)CONTROL
X Standard Pilot
(H)MINIMUM PILOT PRESSURE
H 300 psi (20 bar)
(N)SEAL MATERIAL
N Buna-N
E EPDM
V Viton
MATERIAL/COATING
Standard Material/Coating
/AP Stainless Steel, Passivated
/LH Mild Steel, Zinc-Nickel
NOTE: DATA MAY VARY BY CONFIGURATION. SEE CONFIGURATION SECTION.
This is a normally closed, balanced poppet, switching element. Pilot pressure at port 3 shifts the valve to the open
position.
TECHNICAL DATA
Cavity T-23A
Series 3
Capacity 240 L/min.
Maximum Operating Pressure 350 bar
Minimum Pilot Pressure Required to Shift Valve 20 bar
Maximum Valve Leakage at 110 SUS (24 cSt) 0,7 cc/min.@350 bar
Pilot Volume Displacement 0,82 cc
Valve Hex Size 31,8 mm
Valve Installation Torque 203 - 217 Nm
Seal kit - Cartridge Buna: 990023007
Seal kit - Cartridge EPDM: 990023014
Seal kit - Cartridge Polyurethane: 990023002
Seal kit - Cartridge Viton: 990023006
Model Weight 0.67 kg.
sunhydraulics.com/model/
DKHS
Model Code Example: DKHSXHNCONFIGURATION OPTIONS
c
2025 Sun Hydraulics 2 of 2
TECHNICAL FEATURES
Unique balanced construction provides predictable switching with 5000 psi (350 bar) at both ports 1 and 2, with the external drain open and a minimum pilot
pressure of 300 psi (20 bar).
Port 1 and port 2 are fully sealed from port 3 and port 4. Ports 3 and 4 are positively sealed.
Any backpressure at the drain port is directly additive to the required pilot pressure for reliable operation.
Leakage rate between port 1 and port 2 is very low, typically less than 10 drops/min. at 5000 psi (0,7 cc/min at 350 bar).
Valve will reseat when the pilot pressure falls below 145 psi (10 bar).
Cartridges configured with EPDM seals are for use in systems with phosphate ester fluids. Exposure to petroleum based fluids, greases and lubricants will damage
the seals.
These valves are hydraulically balanced between port 1 and port 2.
All ports will accept 5000 psi (350 bar).
Incorporates the Sun floating style construction to minimize the possibility of internal parts binding due to excessive installation torque and/or cavity/cartridge
machining variations.
PERFORMANCE CURVES