
2
Bosch Rexroth Corporation | RA10540/08.2022
Rineer High Torque Vane Motors | Introduction
Optimum power-to-weight ratio
Four frame sizes with displacements ranging from
6 to 250+ cubic inch (98 to 4096+ cc) displacements (CID).
Starting & stall torque
Applications requiring maximum torque at zero rpm benet
from the vane crossing vane design. Torque curves are virtu-
ally at, with maximum torque at start and stall conditions.
Smooth output over a wide speed range
From less than 10 rpm to 2000 rpm and beyond, this motor
generates low torque ripple and steady acceleration for
smooth operation.
Dynamic braking
The motor is constructed of hardened materials and does
not include any non-ferrous metals. This is a plus when
designing for dynamic braking and overrunning loads.
The cavitation that typically occurs in these circuits does
not affect motor integrity.
4-ported series
4-port motors are available in the 37, 57, and 125 Series.
These motors are made up of two cartridges separated by
a center ported housing. Equal or dissimilar displacements
may be combined to attain desired total cc/rev (CID).
When supplied with external valving, they can be used
as either 2- or 3-speed motors.
High performance series
The 37D, 57D, and 125H are now part of the family of
motors. This high performance design is for 4500 psi
(310 bar) “continuous” service, and boosts torque and
horsepower by 50% providing the same wide speed range
of standard motors.
Unique vane crossing vane design
provides maximum versatility
The Rineer motor is created around a vane crossing vane design,
a leading-edge concept in uid power transmission, which allows
for low speed/high torque and high speed/high torque. With over
70+ displacements combined with a variety of optional features,
this is one of the most versatile hydraulic motors in the world.