12-39
Catalogue HY11-3500/UK
Pressure Switch
Series PSB
12
PSB_UK.INDD RH_18.05.10
Parker Hanniļ¬n GmbH
Hydraulic Controls Division
Kaarst, Germany
Characteristics
Symbol DIN 24340
Design plunger type switch
Mounting PSB*F1* ļ¬ange (front face)
PSB*V1 pipe mounting
Mounting position as desired
Weight [kg] 1.0
Operating pressure [bar] to 315
Actuating pressure difference see diagram
Duty cycle max. 1/s
Pressure ļ¬uid mineral oil (HL, HLP) as per DIN 51524, other pressure ļ¬uid on request
Te mperature range [Ā°C] -20...80
Viscosity range [mmĀ²/s] 12...400
Electrical connection plug-in connector to EN 175301-803
Insulation IP65 as per EN 60529
Contact load carrying capacity 5A at 250VAC; 1A at 50VDC; 0.2A at 250VDC
The electro-h ydraulic pressure switch provides an electric
signal when the sensed pressure goes above or below
the selected setting.
Function
The spring loaded piston is hydraulically dampened. The
PSB provides a very accurate hysteresis between the
switching points (see diagram).
The required operating pressure is adjusted by the set-
screw. Unauthorised adjustments can be prevented by
the optional cylinder lock.The electric element is a micro
switch with snap-action contact. Three terminals permit
application as "On", "Off" or "Changeover" switch.
The electrical connection is made with a 3-pole plug-in
connector to EN 175301-803 with ground.
Note
ForinductiveDCloads asparkdischarger should be used
to increase service life.
Features
ā¢ Flange or pipe mounting
ā¢ 4pressure ranges
ā¢ Can be used as opener or closer
ā¢ Cylinder lockoptional
Technical data