Symbol
Description
A solenoid-operated, 2 port, normally closed, poppet-type, screw-in hydraulic cartridge
valve, designed to function as a load holding or blocking valve in applications requiring
low internal leakaget.
Operation
When de-energized, the SV10- P20AX acts as a check valve, allowing flow to pass from
port 1 to port 2, while blocking flow in the reverse direction. When energized, the poppet
lifts to the port 2 to port 1 flow path. in this mode, flow from 1 to 2 is severely restricted.
Features
Integral position sensor indicates when valve is shifted.
Continuous-duty rated coil.
Hardened seat for long life and low leakage.
Optional coil voltages and terminations.
Efficient wet-armature construction.
Cartridges are voltage interchangeable.
Waterproof E- Coils rated up to IP69K.
Unitized, molded coil design.
960 hour salt-spray rated solenoid tubes and coils.
All HyPerformance products are tested to NFPA specification T2.6.1 and are tested at a
verification level of 90% and an assurance of 99%.
Overview
Ratings
Pr e ssur e Ratings
Pressure rating
350 bar (5075 psi)
Proof pressure
690 bar (10,000 psi)
Burst pressure
1380 bar (20,000 psi)
Flow Ratings
Flow rating
113.6 lpm (30 gpm)
Maximum internal leakage
7 drops/min - Note : With 350 bar (5075 psi)
1.3 lpm (0.4 gpm) - Note : Typical flow (leakage) in transition at 350 bar
(5075 psi). (see "Flow vs % Valve Shift" graph for flow in transition from valve
close to valve open).
Othe r Ratings
Cycle life
One million cycles (500,000 cycles per flow direction)
Response
0.039 sec - Note : Pull-in. Response times measured per NFPA/T3.5.30-2008
*Inlet pressure 345 bar (5000 psi) *Valve oriented vertically (2-1) and purged of
air *Valve oriented horizontally (1-2) and purged of air
0.039 sec - Note : Drop-out. Response times measured per NFPA/T3.5.30-
2008 *Inlet pressure 345 bar (5000 psi) *Valve oriented vertically (2-1) and
purged of air *Valve oriented horizontally (1-2) and purged of air
Te mpe rature Ratings
Operating fluid temperature
-40 to 100 ° C (-40 to 212 °F) - Note : With buna N seals
-26 to 204 ° C (-15 to 400 °F) - Note : With fluorocarbon seals *See Position
sensor operating temperature*
-54 to 107 ° C (-65 to 225 °F) - Note : With urethane seals *See Position
sensor operating temperature*
Storage temperature
-40 to 70 °C (-40 to 160 °F)
Ambient temperature
-40 to 70 °C (-40 to 160 °F)
Position sensor operating
temperature
-40 to 110 ° C (-40 to 230 °F) - Note : Sensor element operating temperature
limits the operating temperature of the entire assembly