E 5.991.1.0/12.10
518
Proportional Pressure Relief Valve
SAE 8-Cartridge – 350 bar
PDB08P-01
Spool Type – Pilot Operated
60 l/min
350 bar
The PDB08P is a two stage spool type
proportional pressure relief valve. If
the pressure at port 1 rises above the
setting dened by the electrical control
signal, the pilot stage opens and allows
ow from the back of the main piston to
port 2. The resulting pressure imbalance
causes the main piston to open against
the return spring and allows ow from
port 1 to port 2. As a function of the
electrical signal the relief pressure at
port 1 can be changed steplessly.
Features
z All surfaces zinc-plated and corrosion proof
z All valve parts made of high-strength steel with hardened and ground
components to ensure minimal wear and to extend service life
z Rigid design using one-piece body minimizes the effect of eccentricity and
maximizes reliability
z Waterproof design standard
z Wide variety of connectors available
z Excellent stability throughout ow range
z Excellent dynamic performance
z Low pressure drop by CFD optimized ow-path
z Screen protected measuring orice enhances safety
FuNctION
specIFIcatIONs
Operating pressure: max. 350 bar
Nominal ow: max. 60 l/min
Operating pressure ranges: up to 60 bar, up to 230 bar, up to 350 bar
Control current range: 1050 mA, 8.8 Ω / 2100 mA, 2.2 Ω
Internal leakage: less than 0.5 l/min at 350 bar
Media operating temp. range: -20 °C to +120 °C
Ambient temp. range: -20 °C to +60 °C
Dither frequency: 180 Hz - 250 Hz
Response time: On: approx. 50 ms, Off: approx. 30 ms
Hysteresis with dither: 2 - 4 % of maximum control current
Repeatability: 1.5 % of maximum pressure range
Reversal error: ≤ 2 % of maximum control current
Response sensitivity: ≤ 1 % of maximum control current
Fluids: Mineral-based or synthetics with
lubricating properties
Viscosity: 7.4 to 420 mm²/s
Filtration: Class 18/16/13 up to 19/17/14 according
to ISO 4406 or cleaner
Installation: no orientation restrictions
Material: Valve body: carbon steel
Spool: carbon steel
Seals: NBR (standard)
FKM (optional)
Coil: Steel / Polyamide
Notes:
The PDB08P can also be supplied with an emergency pressure adjustment (version
-01M). This allows a mechanical pressure adjustment of the valve if the electrical signal
is interrupted. This adjustment should be used only in the case of electrical failure since
the manual setting would be additive to the electrical setting and the danger of equipment
damage could develop.
In order to achieve optimal function, any trapped air should be vented with the bleed
screw on the face of the tube (not tted to version -01M).
Cavity: FC08-2
Weights: Valve complete: 430 g
Coil only: 230 g