EATON Screw-In Cartridge Valves E-VLSC-MC001-E December 2009 B-260.A
An Eaton Brand
B
Where measurements are critical request certified drawings. We reserve the right to change specifications without notice.
EFV2-12-O - Proportional Valve
Proportional flow, normally open spool
Up to 114 L/min (30 USgpm) • 210 bar (3000 psi)
Description
This is a three port pressure
compensated normally open
proportional flow control
screw in cartridge valve. The
valve can be used as a prior-
ity or a restrictive style valve
allowing the valve to control
the outlet flow with the option
of the excess flow being used
for another system.
Operation
Current supplied to the coil con-
trols the valve. At zero current,
the valve is fully open from port
1 to port 3. At 1600 mA (12V
coil) the valve is fully closed.
The valve will regulate flow out
of port 3 regardless of down-
stream system pressure. As
current is increased to the sole-
noid the flow out of port 3 will
decrease.
Features
Hardened and ground working
parts to give long life with
good control; Compact design
with low pressure drop.IP69K
Tough coil compatibility, con-
tinuously rated.
1
Ratings and Specifications
Performance data is typical with fluid at 21,8 cST (105 SUS) and 49°C (120°F)
Typical application pressure 210 bar (3000 psi)
Cartridge endurance rating 1million cycles
Cartridge fatigue pressure (infinite life) 210 bar (3000 psi) NFPA rated
Rated flow “A” Spool-max regulated flow (by-pass mode): 53 L/min (14 USgpm)
max regulated flow (2 port mode): 42 L/min (11 USgpm)
max input flow (input flow): 114 L/min (30 USgpm)
“B” Spool-max regulated flow (by-pass mode): 38 L/min (10 USgpm)
max regulated flow (2 port mode): 31 L/min (8 USgpm)
max input flow (input flow): 114 L/min (30 USgpm)
Note: Max regulated flow may decrease slightly during compensation.
Internal leakage (fully closed) 77-483 cm
3
/min (5-30 in
3
/min) @ 3000 PSID
Nominal supply voltage 12/24 V
Current to fully open valve 350 100 mA (12V coil), 800 100 mA (24V coil)
Current to fully close valve 1600 200 mA (12V coil), 800 100 mA (24V coil)
Recommended PWM frequency 200-400 Hz
Coil resistance 4.7v /12V, 19.0 /24V
Mass Cartridge only 0,37 kg (0.82 lb), cartridge with coil and end nut 0,73 kg (1.62 lb)
Temperature range -30° to 90°C (-22° to 194°F)
Maximum oil temperature 120°C (248°F)
Maximum internal coil temperature 200°C (392°F)
Cavity C-12-3
Fluids All general purpose hydraulics fluids such as: MIL-H-5606, SAE 10, SAE 20, DTE 24, etc.
Filtration Cleanliness code 18/16/13
Housing material (standard) Aluminum or steel
Hysterisis 1.5 USgpm with 400Hz PWM driver
Seal kit 9900171-000 (Buna-N), 9900172-000 (Viton
®
)
Viton is a registered trademark of E.I. DuPont
Performance Data
Sectional View
1
2
3