EATON Screw-In Cartridge Valves E-VLSC-MC001-E December 2009A-190.A
An Eaton Brand
A
Where measurements are critical request certified drawings. We reserve the right to change specifications without notice.
Ratings and Specifications
Performance data is typical with fluid at 21,8 cST (105 SUS) and 49°C (120°F)
Typical application pressure (all ports) 210 bar (3000 psi)
Cartridge fatigue pressure (infinite life) 210 bar (3000 psi)
Rated flow 114 L/min (30 USgpm)
Internal leakage (port 2 to port 1) less than 5 drops/min, max @ 210 bar (3000 psi)
Temperature range -40° to 120°C (-40° to 248°F)
Coil duty Continuous from 85% to 110% of nominal voltage
Response times (100% rated voltage and flow) Energize: 75 ms
De-Energize: 150 ms
Cavity C-12-2 or C-12-2U
Add “U” after number if undercut is required. If undercut is not specified,
expect 10 psi @ 15 USgpm and 20 psi @ 30 USgpm higher pressure drop.
Fluids All general purpose hydraulic fluids such as:
MIL-H-5606, SAE 10, SAE 20 etc.
Filtration Cleanliness code 18/16/13
Housing material (standard) Aluminum
Weight including coil 0,336 kg (0.74 lbs)
Seal kit 02-165889 (Buna-N), 02-165888 (Viton
®
)
Viton is a registered trademark of E.I. DuPont
SV3-12-C/CM/CR - Solenoid Valve
2-way, 2-position, normally closed, poppet type solenoid valve
114 L/min (30 USgpm) • 210 bar (3000 psi)
Description
This is a 2-way, 2-position,
poppet type, pilot operated,
normally closed solenoid valve.
This valve is used in applica-
tions requiring low leakage,
such as load holding applica-
tions or as a general purpose
diverter or dump valve.
Operation
In the de-energized position
the valve blocks flow from port
2 to 1 and free flow is allowed
from port 1 to 2.
When the solenoid is ener-
gized the pilot poppet is pulled
off the seat allowing the valve
to open in both directions.
Features
Hardened and ground work-
ing parts. Lapped seat for low
leakage. IP69K Tough coil com-
patibility. Continuously rated.
Compact design with low
pressure drop.
Performance Data
Sectional View
Pressure Drop Curves
Cartridge only
A - Port 1 to port 2 de-energized
B - Port 2 to port 1 energized
2
1
100
0
50
150
200
Pressure Drop - psi
14
10
6
1
Pressure Drop - bar
A
B
20 40 60 80 100 1140
Flow - L/m in (21,8 cSt oil @ 49°C)
302520151050
Flow - U Sgpm (105 SUS oil @ 120°F)
2
1
EATON Screw-In Cartridge Valves E-VLSC-MC001-E December 2009 A-191.A
An Eaton Brand
A
Where measurements are critical request certified drawings. We reserve the right to change specifications without notice.
2X 10.31
(.406)
88.9
(3.50)
88.9 (3.50)
63.5 (2.50)
63.5
(2.50)
12.7
(.50)
60.3
(2.37)
12.7
(.50)
28.7
(1.13)
25.4
(1.00)
2
1
Dimensions
mm (inch)
Torque cartridge in housing
A - 81-95 Nm (60-70 ft lbs)
S - 102-115 Nm (75-85 ft lbs)
Note: When solenoid valve is
ordered as cartridge only, coil
nut is included.
Note: Use J series, 23 W
coils with this solenoid valve.
SV3-12-C/CM/CR - Solenoid Valve
2-way, 2-position, normally closed, poppet type solenoid valve
114 L/min (30 USgpm) • 210 bar (3000 psi)
1
Function
SV3 - Solenoid valve
2
Size
12 - 12 size
3
Seal Material
Blank - Buna-N
V - Viton
®
4
Style
C - Normally closed
5
Manual Override Option
Blank - No manual override
M - Knob type
R - Cable type
For valve dimensions with manual over-
ride option installed see page A-980.
6
Valve Housing Material
Omit for cartridge only
A - Aluminum (standard)
S - Steel
9
Connector Types
Blank - No coil
G - ISO 4400 DIN 43650
Q - Spade terminals
W - Flying lead
N - Deutsch (DC only)
Y - Amp JR (DC only)
D - Metripack 150 male
(DC only)
J - Metripack 280 male
(DC only)
10
Special Features
00 - None
(Only required if valve has special
features, omitted if “00.”)
Code Port Size Housing Number
Aluminium Steel
0 Cartridge only
4G 1/2" BSPP 02-161118 02-172062
4GU 1/2" BSPP 02-161116 02-172512
6G 3/4" BSPP 02-161117 02-169665
6GU 3/4" BSPP 02-161115 02-162922
10T SAE 10 02-160640 02-169744
10TU SAE 10 02-160641 02-169817
12T SAE 12 02-160644 02-169782
12TU SAE 12 02-160645 02-169790
See section J for housing details.
7
Port Size
8
Voltage Rating
00 - No coil
12D - 12VDC
24D - 24VDC
36D - 36VDC
24A - 24VAC
115A - 115VAC
230A - 230VAC
12B - 12VDC/w diode*
24B - 24VDC/w diode*
*Optional arc suppression diode.
Model Code
2 3 4 5 6 8 9 101
SV3 12 (V) C (*) (A) **** * 00
7
***
WARNING
Maintain 5-8 Nm
(4-6 ft lbs) maximum
torque on valve tube nut.
Over tightening may cause
valve failure.
•
Installation Drawing (Aluminum)Cartridge Only
– – – – – –
