44 101/120 ED
25/28
BD*
SERIES 10
Seals:
N = NBR seals for mineral oil (standard)
V = FPM seals for special fluids
Series no.
(the overall and mounting dimensions remain unchanged
from 10 to 19)
Size = thickness 38 mm
Solenoid tube (mm):
L = 14
M = 19
Ports:
B38 = 3/8” BSP
S06 = 9/16” 18 UNF (SAE 06))NF (SAE 06)
Spool type
Series design
with sloped hole for T1 path.
Stack directional
valve element, on-off
BD 2 - -C S4 / 10 /-
Coil type (see paragraph 1.1)
Coil electrical connection: (see paragraph 1.1)
Manual override (see par. 10.6 - 10.8):
for BDL:
omit for manual override boot protected
integrated in the coil locking ring (standard)
CK1 = turning knob override
for BDM:
omit for pin manual override integrated in
the tube (standard).
CM = manual override boot protected
CK1 = turning knob override
14 - IDENTIFICATION CODES OF SEPARATE ELEMENTS FOR BDL2 AND BDM2 SERIES CIRCUITS
14.1 - Directional valve element
This code identifies BD*2 elements, designed for series connection. Series circuits with BD*3 modules are feasible by inserting plugs to divert
the oil path (see paragraph 13.2).
NOTE: if no unloading valve is needed,
the identification code ends with seals digit.
Example: BD3-B38S-S140-Q/10N
Material:
S = Steel (standard)
S- B38
Series inlet element with pressure relief valve
K = with unloading valve. Omit if not required.
Seals:
N = NBR seals for mineral oil (standard)
V = FPM seals for special fluids
Series no.:
(the overall and mounting dimensions remain unchanged
from 10 to 19)
14.2 - Inlet elements for flow control valve
/ /10S -- Q-
Manual override of unloading
valve:
CS = screw
CP = push
CPK= push and twist
Pressure relief valve adj. range:
140 = up to 140 bar
210 = up to 210 bar
320 = up to 320 bar
Mounting interface ISO 6263-03 style for flow control valve
(to be ordered separately, see catalogue 82220).
Nominal size
Ports size:
3/8” BSP (standard)
Stackable
BD 3
Coil type of the unloading valve:
DC coil
D12 = 12 V
D24 = 24 V
D28 = 28 V
Coil electrical connection of the unloading
valve:
K1 = plug for connector type EN 175301-803
(ex DIN 43650) (standard)
For D12 and D24 coils only:
K7 = plug DEUTSCH DT04-2P for male
connector type DEUTSCH DT06-2S
K2 plug for connector type AMP JUNIOR
upon request.