21 100/117 ED
1/2
21 100/117 ED
CR
DIRECT OPERATED
PRESSURE CONTROL VALVE
SERIES 22
PERFORMANCES (measured with mineral oil of viscosity 36 cSt at 50°C) HYDRAULIC SYMBOL
OPERATING PRINCIPLE
SEAT DIMENSIONS: D-10E
— The CR valve is a direct operated pressure control valve
cartridge type that can be used in blocks or panels with
type D-10B seat.
— It is normally used to control the maximum pressure in the
hydraulic circuits or as a limiting device for pressure peaks
generated during hydraulic actuator movement variation.
— It is available in five different pressure control ranges up to
350 bar.
— The circuit pressure acts on the shutter which is directly
loaded by a spring on the opposite side. Once the set
pressure is reached, the shutter opens, and discharges the
excess flow in port T connected directly to the reservoir.
— The pressure can be adjusted by a screw, usually supplied
as the countersunk hex type, equipped with locking nut and
maximum adjustment limiter.
CARTRIDGE TYPE
p max
350 bar
Q max 50 l/min
Max working pressure bar 350
Minimum controlled pressure and pressure drop see diagram
Maximum flow rate l/min 50
Ambient temperature range °C -20 / +60
Fluid temperature range °C -20 / +80
Fluid viscosity range cSt 10 ÷ 400
Fluid contamination degree
According to
ISO 4406:1999 class 20/18/15
Recommended viscosity cSt 25
Mass kg 0,16
Surface treatment: electrolytic zinc covering
Fe / Zn8 /B
ISO 2081