SV - Solenoid Valves
SV - 98
Solenoid Valves Catalog
11141717 • Rev BB • May 2015
PERFORMANCE CURVES
APPLICATIONS
OPERATION
SPECIFICATIONS SCHEMATIC
Pressure drop
33 cSt [154 SUS] hyd.oil @ 38°C [100°F]
3 to 1 or 1 to 3
Energized
2 to 1 or 1 to 2
De-Energized
4.0
7.9
30
35
l/min
0510 15 20 25
US gal/min
9.26.65.32.61.3
barpsi
00
229
58 4
687
8116
12174
14510
Solenoid Valve, Spool Type, 2-Position, 3-Way, Normally Closed, Pull-
Type. When de-energized, the SV10-23-01 allows ow from port 1
to port 2, while port 3 is blocked. When energized, ow is allowed
from port 3 to port 1, while port 2 is blocked. Follow the “Operating
Envelope” limits to ensure shifting of the valve during operation.
This valve comes standard with a one-direction, push-pin manual
override.
Rated pressure* 230 bar [3300 psi]**
Rated ow at 7 bar
[100 psi]
28 l/min
[7 US gal/min]
Weight 0.42 kg [0.93 lb]
Cavity SDC10-3
Standard Coil M16 26 Watt
Robust Coil R16 20 Watt
Robust Nut P/N 173804910
(no coil O-rings needed)
SV10-23-01
2-Way, 2-Position Spool
These spool-type valves are commonly used in a selector circuit, or as
an on/o pilot control for a directional spool valve. Solenoid spool-
type valves are direct acting and respond quickly to coil voltage
input. Spool valves will have some leakage due to spool clearance, so
if your application requires no leakage at the working port(s), apply
a low leakage poppet valve(s), like PO check valve, counterbalance
valve, etc., in addition to this solenoid valve. This valve can operate
with an inlet pressure of 315 bar for 400,000 cycles. In case of inlet
from port 2 this value can be increased to 600,000 cycles.
* Rated Pressure based on NFPA fatigue test standards (at 1 Million Cycles).
** See 315 bar pressure rating note on page 10.
Shown with Robust Coil,
Metri-Pack Type 2 Connector
SV10-23-01
Shown with Robust Coil,
Metri-Pack Type 2 Connector