SV - Solenoid Valves
SV - 96
Solenoid Valves Catalog
11141717 • Rev BB • May 2015
PERFORMANCE CURVES
APPLICATIONS
OPERATION
SPECIFICATIONS SCHEMATIC
Pressure drop
33 cSt [154 SUS] hyd.oil @ 38°C [100°F]
116
58
29
2
0
8
6
4
0
10
87
psi bar
l/min
0
US gal/min
2
0.5 1.1
De-energized
1 to 2 or 2 to 1
Energized
3 to 1 or 1 to 3
4 6810 12 14 16 18
2.11.6 3.7 4.83.22.6 4.2
145
Solenoid Valve, Spool Type, 2-Position, 3-Way, Normally Closed, Push-Type.
When de-energized, the SV08-23-01 allows ow from port 1 to port 2, while
port 3 is blocked. When energized, ow is allowed from port 3 to port 1,
while port 2 is blocked. Follow the “Operating Envelope” limits to ensure
shifting of the valve during operation. This valve comes standard with a
one-direction, push-pin manual override.
Rated pressure* 230 bar [3300 psi]**
Rated ow at 7 bar
[100 psi]
17 l/min
[4.5 US gal/min]
Weight 0.31 kg [0.68 lb]
Cavity SDC08-3
Standard Coil M13 20 Watt
Robust Coil R13 16 Watt
Robust Nut P/N 173800539
(no coil O-rings needed)
SV08-23-01
SV08-23-01
2-Way, 2-Position Spool
These spool-type valves are commonly used in a selector circuit, or as an
on/o pilot control for a directional spool valve. Solenoid spool-type valves
are direct acting and respond quickly to coil voltage input. Spool valves will
have some leakage due to spool clearance, so if your application requires
no leakage at the working port(s), apply a low leakage poppet valve(s), like
PO check valve, counterbalance valve, etc., in addition to this solenoid valve.
This valve can operate with an inlet pressure of 315 bar for 400,000 cycles. In
case of inlet from port 2 this value can be increased to 600,000 cycles.
* Rated Pressure based on NFPA fatigue test standards (at 1 Million Cycles).
** See 315 bar pressure rating note on page 10.
Shown with Standard Coil,
Deutsch Connector