6/14 DBET(E) | Proportional pressure relief valve, directly operated
Bosch Rexroth AG, RE 29162, edition: 2013-06
Technical data
(for applications outside these parameters, please consult us.)
Notice!
Information on the environment simulation testing for the areas
EMC (electromagnetic compatibility), climate and mechanical
load, see data sheet 29162-U (declaration on environmen-
talcompatibility).
Hydraulic fluid Classification Suitable sealing materials Standards
Mineral oils HL, HLP NBR, FKM DIN 51524
Bio-degradable – Insoluble in water HEES FKM VDMA24568
Flame-resistant – Water-free HFDU FKM ISO 12922
– Containing water HFC (Fuchs Hydrotherm 46M,
Petrofer Ultra Safe 620)
NBR ISO 12922
Important information on hydraulic fluids!
▶ For more information and data on the use of other hydraulic
fluids refer to data sheet 90220 or contact us!
▶ There may be limitations regarding the technical valve data
(temperature, pressure range, life cycle, maintenance inter-
vals,etc.)!
▶ The flash point of the hydraulic fluid used must be 40 K higher
than the maximum solenoid surface temperature.
▶ Flame-resistant – containing water:
– The maximum pressure differential per control edge is 210 bar.
Otherwise, there is increased cavitation erosion.
– Life cycle as compared to operation with mineral oil HLP
30to100%
– Maximum fluid temperature 60 °C
▶ Bio-degradable: When using bio-degradable hydraulic fluids that
are zinc-solving, zinc may accumulate in the fluid (700 mg zinc
per pole tube).
electric G24 G24-8
Minimum solenoid current mA ≤ 100 ≤ 100
Maximum solenoid current mA 1600 ± 10 % 800 ± 5 %
Solenoid coil resis-
tance
– Cold value at 20 °C Ω 5,5 20,6
– Maximum hot value Ω 8,05 33
Switch-on duration % 100 100
electric, integrated electronics (OBE)
Supply voltage – Nominal voltage VDC 24
– Lower limit value VDC 21
– Upper limit value VDC 35
Current consumption A ≤ 1,5
Required fuse protection A 2, slow-blowing
Inputs – Voltage V 0 to 10
– Current mA 4 to 20
Output – Actual current value mV 1 mV ≙ 1 mA
Protection class of the valve according to EN 60529 IP 65 with mating connector mounted and locked