20/24 350LEN0040 to 1000; 350LE0130, 0150 | Inline filter
Bosch Rexroth AG, RE 51422, edition: 2015-03
Assembly, commissioning, maintenance
Assembly
▶ The max. operating pressure of the system cannot
exceed the max. admissible operating pressure
of the filter (see name plate).
▶ When assembling the filter (see also “Tightening
torques”), note the flow direction (arrows) and the
required servicing height of the filter element
(see “Dimensions”).
▶ Filter element exchange is made easiest when the filter
bowl is oriented downward. Ensure the maintenance
indicator is easily visible.
▶ Remove the plastic plugs in the filter inlet and outlet.
▶ Make sure power is disconnected during assembly.
▶ The optional electrical maintenance indicator is con-
nected using the electronic switching element with
1 or 2 switching points, which is placed on the mechan-
ical visual maintenance indicator and held in place
by a locking ring.
Commissioning
▶ Commission the system.
Important:
The filter has no bleeding mechanism.
Maintenance
▶ If the red indicator pin rises out of the mechanical
visual maintenance indicator and/or the electronic
switching element switches at operating temperature,
the filter element is dirty and has to be replaced/
cleaned. For more details, see data sheet 51420.
▶ The material number of the correct replacement filter
element is on the name plate of the complete filter. Verify
that it matches the material number on the filter element.
▶ Decommission the system.
▶ Release operating pressure on the system side.
Important:
The filter has no bleeding mechanism.
▶ Drain the oil on the dirt side using the drain screw
(size 0160 and larger).
▶ Unscrew the filter bowl (or base if size 1000).
▶ Slightly turn the filter element to remove it
from the spigot.
▶ Clean the filter components as needed.
▶ Check the seals on the filter bowl for damage and
replace them as needed.
For compatible seal kits, see “Spare parts”.
▶ Wire mesh filter elements can be cleaned. For detailed
cleaning instructions, see data sheet 51420.
▶ Slightly turn the new or cleaned filter element to install
it on the spigot.
▶ Assembly is reverse of removal.
▶ Note the torque specifications (“Tightening torques”).
▶ Commission the system.
Important:
▶ Only trained specialists may work on the filter.
▶ The safety and functionality of the filter are only guar-
anteed with original Bosch Rexroth spare parts.
▶ The warranty will be void if the delivery item is
modified or improperly mounted, installed, main-
tained, repaired or used by the ordering party or a
third party, or exposed to environmental conditions
exceeding our installation conditions.
WARNING
▶ Only install or remove when system is not pressurized.
▶ Filter is pressurized.
▶ Only remove filter bowl when it is not pressurized.
▶ Do not replace maintenance indicator when filter
is pressurized.
▶ Failure to observe flow of direction during assembly
will cause filter element to be damaged beyond repair.
Particles will enter the system and damage down-
stream components.