I • 32File: AD5EJ$2_E 02/2000/e

OVERALL DIMENSIONS

EAD5E...Q5 - 02/2000/e

EAD5E...J$ - 00/2000/e

AD.5.E...J* VALVES WITH SPOOL MOVEMENT SPEED CONTROL VARIANT J*

Valves type AD5.E... with spool movement speed control variant J*

These ON-OFF type valves are used when a lower spool movement

speed than usual for conventional solenoid valves is required to prevent

impacts which could adversely affect the smooth running of the system.

The system consists of reducing the transfer section for the fluid from one

solenoid to the other by means of calibrated orifice.

• This version can only be used with a direct current (DC) and also

involves a reduction in the limits of use so that we suggest to always

test the valve in your application.

E = Manual override

Max. pressure ports P/A/B 320 bar

Max. pressure port T - see note (*) 250 bar

Max. flow 100 l/min

Duty cycle 100% ED

Fluid viscosity 10 ÷ 500 mm

Fluid temperature -25°C ÷ 75°C

Ambient temperature -25°C ÷ 60°C

Weight with one DC solenoid 3,6 Kg

Weight with two DC solenoids 4,5 Kg

(*) Pressure dynamic allowed for 2 millions of cycles.

CALIBRATED

ORIFICE

AVAILABLE

ø (mm) M6x6 Code

0.5 M89.10.0031 J5

0.6 M89.10.0026 J6

0.7 M89.10.0032 J7

0.8 M89.10.0033 J8

Fixing screws UNI 5931 M6x40

with material specifications min. 8.8

Tightening torque 8 Nm / 0.8 Kgm

Support plane

specifications

AD.5.E...Q5 VALVES WITH EXTERNAL DRAINING SOLENOID - VARIANT Q5

• To order AD.5.J* version valves, specify the orifices code.

• The operation is linked to a minimum counter-pressure on the

T line (1 bar min.)

• The switching time referred to the spool travel detected by

a LVDT transducer can vary for the NG10 valve a minimum of

200 to a maximum of 400 ms depending on 5 fundamental

variables:

1) Diameter of the calibrated orifice (see table)

2) Hydraulic power for clearance referring to flow and pressure

values through the valve

3) Spool type

4) Oil viscosity and temperature

5) Counter-pressure at T line

• Possible mounting: C / E / F / G / H

• 19 / 20 / 21 spools not planned for variant J*

E = Manual override

Valves type AD5.E... variant Q5 with external draining solenoid

This involves valves with solenoid drainage chambers separated by

line T in the CETOP 5 interface distinguished by the letter L. This

solution makes it possible to operate with a maximum counter-

pressure at T up to 320 bar using only 12.9 material fixing screws to

ensure the maximum safety of the solenoid valve fixing and use of an

additional drain. This version can be used for direct current (DC) and

alternating current (AC), but involves a reduction in the limits of usage

depending on the pressure at T.

• Mounting possible: C / D / E / F / G / H / I / L / M

• For subplate see BSH.5.31..

Max. pressure ports P/A/B/T 320 bar

Max. pressure port L (DC coils) see note (*) 250 bar

Max. pressure port L (AC coils) 160 bar